 | | PDS |
|
|
This little board is redesigned version of obsolete PEDSCAN-X. It is a scanner of up to 32 contacts and two potentiometers. It usually finds its place in pedals of organ consoles. The board shown above has 12 soldering pads at the top for diode matrix needed to connect contacts, 4 pads on the right for the potentiometers, and 4-pin connector for connecting to master controller.
As a standard it comes with 1.5m (5ft) cable to master controller. It is highly recommended to install this board at the pedals, so only inter-board cable is lead from the floor to upper console. The cable to potentiometers must also be short, preferably no more than 30cm.
As any other scanner board, this one cannot work just by itself, but it needs one of the master controllers to operate.
Features:
- scans 32 contacts in 4x8 diode matrix
- scans two potentiometer or external voltages
- user defined update rate and resolution of the pot inputs
- usable with
MRG2,
MRG3,
MBBS,
MIDI128,
MPOT32
- includes cable to master controller
- dimensions: 31x17mm (1.2'' x 0.7'')
Here is the diode matrix needed for PDS to work properly:
Email for details | |
PRODUCTS: